How to create a 3D jewellery set

What you have to have:

Results – These can be distinctive dependent on personalized choices:

Tools:               

Recommendations:

1. To start with you will need to have to saw/file the sprue off the pieces
2. You can pre buff/ pre polish the star parts which can make cleaning less complicated after soldering
3. Employing buff sticks to buff back again the forged finish heading from coarse to high-quality
4. When you have received to good buff paper you can start to polish using luxi compound –blue for to start with phase with the calico mop
5. There are guideline marks on the issue of the star pendant and earrings you want to solder jump rings to
6. You can file jump rings with triangular file to give them an angle at the ends so they sit flat in opposition to the level of the star
7. Use solder paste wherever the tutorial marks are on the stars
8. On the soldering block, force the soar ring in opposition to the stars guideline marks and use tweezers to maintain the soar ring in area
9. Working with the hand torch, heat up the reliable star and when it is beginning to switch colour slowly and gradually shift alongside to the leap ring so it gets to tempreture at identical time till the solder melts and joins the pieces alongside one another
10. Quench and place it in pickle, rinse soon after pickling to wash off acids.
11. If you did not buff and pre polish beforehand now you will want to buff again the cast end and if you need to have to clear away any more solder
12. Polish the piece employing luxi compound – blue for first phase using a calico mop
13. Then polish with White luxi compound and a fluffy mop
14. For your earrings you can open up up your ear wire and then close it back together
15. For the star pendant necklace, dependent on the bail you pick out you can either increase it immediately the the bounce ring or if demanded you may possibly need to add an additional smaller leap ring in advance of the bail.
16. Ultrasonic or cleanse off any residual polish and increase a chain to the pendant.

Optional: you can possibly wholly close your results by soldering them through soldering stage 9 or depart the results semi open up and just pushed alongside one another .

Help save this for later